Step Type:

Drag to rearrange

Make sure that you have completely removed the filament from the extruder_body.

Slide an extruder spring onto a M3x40 screw.

Close the extruder_idler door.

Slide the screw with the extruder spring into the extruder_body.

Tighten the screw into the extruder_idler until the head is flush with the surface of the body.

If you have trouble closing the extruder_idler, try rotating the Bondtech idler gear, with a finger, to ensure that the gears are meshed.

Your contributions are licensed under the open source Creative Commons license.