After few seconds you should get the Err: MINTEMP error message displayed on the printer.
Set targeted temperatures back to 0°C via Preheat/Cooldown or Settings/Temperature menu.
Quickly plug back the hotend thermistor and let the hotend cool down under 50°C.
Turn the printer off after Hotend and Bed are cooled down. Turning off the printer while the Hotend is above 50°C can cause heat creep!
If this step behaves differently please verify your connection and firmware. If it continues stop using your printer and contact us or ask for help.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.