Step Type:

Drag to rearrange

Place the y_motor_endstop_mount, as shown, and secure it with 1x M3x18 screw.

Place the Y end stop on the y_motor_endstop_mount with the switch actuator aligned with the notch, as shown.

Make sure the orientation of the switch is correct!

Insert and tighten 2x M2x12 screws to secure the end stop. Do not over tighten these screws, otherwise you may damage the end stop.

If it is too hard to tighten the M2 screws into the end stop mount, you may use a 1.5mm drill bit to clear the holes. Be careful that you do not break the drill bit.

Your contributions are licensed under the open source Creative Commons license.