Step Type:

Drag to rearrange

Remove the M3x25 screw, used during installation, from the y_idler_mount and add a washer to the screw.

Insert the y_idler_tensioner into the y_idler_mount and reinsert the M3x25 screw with its washer.

Insert an M3 locknut into the left side of the y_idler_mount and thread an M3x30 screw from the other side. Use this screw to help seat locknut correctly, in the part. Do not over-tighten this screw, the y_idler_tensioner should move with almost no resistance.

Confirm you have a washer on the M3x25 tensioning screw.

Check that the y_idler_tensioner can move with almost no resistance.

Your contributions are licensed under the open source Creative Commons license.