Editing Step 4 —
Left smooth rod alignment

Step Type:

Drag to rearrange

Take your time with this step, it could affect the alignment of the heatbed later.

Clip 1x Y smooth rod (330mm long) into the y-rod holders, on the left-hand side.

Loosen the 4x M5x12 screws so that the y_rod_holders move easily.

Using the y_build_helper, adjust the position of the front y_rod_holder. Once the alignment is correct, fully tighten the M5x12 screws.

Make sure the y_build_helper is correctly seated against the extrusion and is in contact with the smooth rod.

Using the same y_build_helper, adjust and tighten the rear y-rod holder.

Carefully check the alignment of the front and rear of the smooth rods. You may need to repeat the adjustment to get them perfectly aligned.

Your contributions are licensed under the open source Creative Commons license.