Editing Step 37 —
Y belt installation - MK3(S)

Step Type:

Drag to rearrange

Insert the top section of the belt into the left side of the y_belt_holder. If necessary, use a small slotted screwdriver to help insert the belt. The belt should be inserted to the full depth of the groove .

Make sure the belt teeth are correctly oriented according to the shape of the y_belt_holder.

Continue to route the belt around the Y motor pulley and finish by inserting the belt into the y_belt_holder. The belt should have almost no tension, it will be adjusted later.

If the belt is too long to fit inside the y_belt_holder you can trim the excess.

Verify that the belt is fully inserted into the slot.

Tighten the M3x18 screw to secure the belt.

Your contributions are licensed under the open source Creative Commons license.