Step Type:

Drag to rearrange

Take the X axis motor and plug it into the top left connector (X motor) (4 pins).

This is the same for the MK2(S), MK2.5(S) and MK3(S).

Push the textile sleeve and cable into the hexagonal hole, as shown. Allow some slack in the cable, so as not to put any strain on the connector.

Insert 2x M3x14 screws. Take care that they do not fall out while you are attaching the cover to the mounts.

Attach the electronics cover to the rambo_base_lower_mount by fully tightening the lower M3x14 screw.

Your contributions are licensed under the open source Creative Commons license.