Step Type:

Drag to rearrange

If you can't achieve this trick, simply rotate the frame to its left side. Be careful with the extruder as it will slide down.

Using a hex key (or a zip tie) move the t-nut upper and hold it in place with one hand.

Use a hex key 0f 2.5mm size or lower.

Take the rambo_hinge_lower and add an M5x8 screw in the biggest hole. Hold the part and a 3mm hex key with your other hand as shown in the image.

Place the rambo_hinge_lower on the t-nut and tighten the M5x8 screw. Do not tighten completely yet, we will need to slide it down.

You can remove the smaller hex key once the screw is engaged on the t-nut.

Tech tip: Keep in mind the technique we are using here for later when you will add accessories or do some maintenance on the printer.

Your contributions are licensed under the open source Creative Commons license.