Step Type:

Drag to rearrange

Direct links to the original Prusa electronics assembly guides: MK2(S), MK2.5, MK2.5S

Insert the extruder wiring and textile sleeve (or spiral wrap) through the top of the electronics cover. Secure them with the printed part and 2x M3x10 screws.

The image is showing the electronic cover for MK2.5(S), the MK2(S) version is slightly different. Refer to the Prusa guide if necessary.

Plug the following connectors:

Extruder motor

Extruder heater

Check that all connectors are properly plugged in and no wire is under tension or pinched!

Your contributions are licensed under the open source Creative Commons license.